Közönségmérés Ezek a sütik lehetővé teszik számunkra, hogy optimalizáljuk oldalunkat az Ön kényelme érdekében az Ön használatának módja alapján. A cél az, hogy emlékezzünk vagy előre jelezhessük a választásaikat. Ide tartozik például a funkciók használata, elhelyezkedése, viselkedése az oldalon. Very impressive indeed! Though with this noise level, thanks to modes speed fans by AIO standards, we do wonder if full-speed thermal performance will be compromised slightly. Let’s find out. Analitikai sütik Ezek az Ön tevékenységeinek nyomon követésére szolgálnak adatelemzés céljából, mint például a reklámozás hatékonyságának értékelése, személyre szabott tartalom felajánlása./span>

We decided to test using a chassis as we feel that this is most representative of real-world use cases. It does have some unwanted influences on the test data, as does open-air test bench testing. But we feel that this is a worthwhile trade-off for real-world chassis performance of the coolers. On the top side of the angled plastic pump unit is the 40mm VRM fan. The translucent housing of this fan is not RGB LED lit, and this feels like a missed opportunity by Arctic.

Recommended Products

The majority of Liquid Coolers on the market today are based around Asetek designs, but the Liquid Freezer II features a pump which was designed in-house by Arctic, with the goal of quieter operation and higher efficiency. Like its fans, the water pump is PWM-controlled and will adjust its speeds. This decreases power consumption and leads to lower noise levels in lighter workloads. Our next chart continues with the 3950X 200W load, but allows all the coolers to run at 100% fan speed during the test. This doesn’t move the needle much for Arctic, which seems to top-out in its efficiency at around 1200RPM rather than its maximum 1600RPM. The results were +/-1C as usual, but our average ended up at 50.9 degrees over ambient. That’s not enough of a change, so there’s room to reduce noise level without much loss of overall performance. At the 1610RPM speed, the Arctic cooler ran at 42.5dBA at the normal 20” distance. This puts it about equal in thermal performance to the NZXT Kraken X62 and X72, which run around 51-53dBA, or a perceived noise increase to the human ear of about 2x. Again, that’s perceived to the human ear, not acoustic power, which is a different scale. Either way, Arctic’s solution is significantly quieter at the same performance. The EVGA CLC 360 shows that we’re not limited by our test bench, but also that jet engine levels of noise are needed to drive the temperature down further. 3800X – 35dBA Tartalom személyre szabása Ezek a sütik lehetővé teszik számunkra, hogy az Önről rendelkezésre álló információk alapján tartalmakat és hirdetéseket jelenítsünk meg Önnek, hogy a lehető legjobban ki tudjuk elégíteni az Ön igényeit. Ez legfőképpen ahhoz kapcsolódik, hogy milyen tartalmat tekintett meg, illetve milyen eszközzel lépett be az oldalunkra. Our chassis of choice is the Fractal Design Meshify 2 case that Leo reviewed and scored very highly. We like this chassis thanks to its high airflow optimisation and well-vented front and top panels.

Note the use of delta temperature data in our charts and factor in your own ambient conditions for reference. The VRM fan clearly does something, and temperature improvements will follow the more even FPM on either side of the VRM heatsink, but we also want to be clear that a top-mounted radiator would also benefit the VRM. This is something we simulate in our test setup. VRM Thermals The nature of a review cycle (while a product is relevant) typically dictates that there’s no means to realistically test for endurance or age. We can revisit in the future if needed, but that’s the only question mark left after the review process: Arctic’s pump design is new, something we’ll look at in our tear-down video coming up shortly, and a new design means we have no reference point for endurance and reliability. In general, liquid coolers outlive the usable life of the system, and potentially two systems, but those that fail do so in a much more visible or catastrophic fashion. Failures are overall rare, however, and that’s always important to note. We’ll send you to our Air vs. Liquid cooler content for more of an explanation on this front. Arctic’s unit manages a delta temperature of 65C under these conditions. While that is still not at the level of the Asetek-based Phanteks cooler or Fractal’s highly competitive Apaltek Lumen S36 RGB, it is a very strong result in isolation. And it allows Arctic’s cooler to match some of the AIOs that it was previously struggling to maintain pace with at full fan speed.

ARCTIC Liquid Freezer II 360 A-RGB

dBA at full fan and pump speeds is absolutely fine to set next to for a working or gaming session. I would have no worries about running the Freezer II 360 level of noise on a 24/7 basis, but the excellent PWM fan speed range is also available. Handles the heat perfectly, cpu never gets above 65C. While that sounds high it really isn't for 7000 series cpu. Chassis Fans: 2x140mm 1000 RPM Fractal Front Intake, 1x140mm 1000 RPM Fractal Rear Exhaust, 1x140mm 1000 RPM be quiet! Pure Wings 2 Roof Exhaust (for air cooler testing)

The Liquid Freezer II A-RGB combines the efficient, award-winning PWM pump of the Liquid Freezer II with new A-RGB fans optimised for static pressure. This gives you a whole new aesthetic with extremely low noise and equally low temperatures. A sütik feldolgozásának elfogadásával nélkülözhetetlen és analitikai sütik kerülnek telepítésre eszközére, amelyeket a weboldal megtekintéséhez használ (az "Értem" gombra kattintva mindkét kategóriát elfogadja, vagy kiválaszthhatja a kategóriák közül csak az egyiket a "Beállítások" gombra kattintva). A technikai sütiket mindig telepítjük az eszközére, az Ön beleegyezése nélkül is, mert ezek nélkül a weboldalunk nem működne.A megvilágított P ventilátorokat a gyárban már beépítették a kompakt vízhűtõrendszerbe, a következõ elõnyökkel: The out of the fan direction were different and the mounting kit didn't match the instructions. Was able to piece together fitting instructions and was all good after that The next test will be for the VRM fan. For this, we’re going to start with an overlay demonstrating the linear feet per minute flow, often called FPM or LPM, as measured with a hotwire anemometer at the edge of the chassis for the cooler. The measurement is taken at an angle toward the VRM heatsink. We measured at a few points and under a few conditions. Nem személyre szabott hirdetések Ezek a sütik lehetővé teszik számunkra, hogy általános termék- és szolgáltatásreklámokat jelenítsünk meg Önnek.

Small fans have a reputation for being particularly loud and not very durable. However, we have developed a quiet and durable diagonal fan especially for the Liquid Freezer II and are 100% convinced that this 40 mm fan is just as durable as our other case fans. In the unlikely event that it should fail, our customer service team will send you a replacement free of charge and easily, without a need to replace the entire unit. A Liquid Freezer II szálerõsítésű, hosszú EPDM csöve lehetõvé teszi nagy házakba történõ beépítését, és hatékonyan megakadályozza a hűtõfolyadék elpárolgását, így nem kell aggódnia a kompakt vízhűtési rendszer újratöltése miatt. Interestingly, the three fans are connected to each other via a daisy-chain approach that is pre-routed. This is an excellent solution as the cable management is far cleaner than what a typical end-user could achieve.KitGuru says: The Arctic Liquid Freezer II 360 A-RGB is particularly strong in the noise-balanced performance department. Add competitive pricing, a 6-year warranty, and good RGB fans into the mix, and it is easy to give this cooler a recommendation. Nélkülözhetetlen sütik Ezek elengedhetetlenek a weboldal és funkcióinak működéséhez, amelyek használatáról Ön dönt. Nélkülük nem működne a weboldalunk, például nem tudna bejelentkezni saját fiókjába, vagy bevásárlói listákat létrehozni. A legtöbb más, minden egyben folyadékhűtés-gyártóval ellentétben, 38 mm vastag, nagy bordasűrűségű radiátorokat használunk. Ily módon nagyobb mennyiségű vizet lehet felhasználni az áramkörben, és a hűtési felület jelentõsen megnövelhetõ. The result is, of course, a reduction in maximum cooling capability versus some of the higher fan speed and louder AIOs. But this is actually a compromise that I would be willing to make personally, as the Freezer II 360 A-RGB cooler’s noise output never got to an intrusive level and the cooling performance was always competent, if not chart-topping. A single 4-pin cable controls the radiator fans, pump, and VRM fan – all of which operate under PWM conditions. That means that each of those components was reduced in terms of its operating speed when we targeted the 40dBA noise output.